Artiteq Back Frame Hanging System Rail 300 cm

The Artiteq Back Frame Hanging System Rail is a mounting system specially designed for thin and flexible panels made of aluminum (Dibond), Forex, acrylic, or Plexiglas. This system allows panels to be hung floating (blind).

Using the Artiteq Back Frame Hanging Rail makes hanging printed panels simple and safe, and also makes the panels stronger, as the force is distributed across all four sides of the rail. The frames are attached to the back of the wall panel and are therefore not visible from the front.

The Back Frame Hanging System Rail is available with an 8 or 15 mm profile in the following finishes: clear aluminum and silver anodized.

This product only includes the rail with a total length of 300 cm. To use it, the rail must be mitered with a hacksaw. 3M tape must also be applied to the rail. Would you prefer a Back Frame Hanging System Rail that is ready to use? Then check out the kits, where the 3M tape is already attached and the rail is professionally custom-made in various lengths. Finally, to use the Artiteq Back Frame Hanging System Rail, the Back Frame Power Corners must be installed. The panel is hung on the Back Frame Corners, no additional accessories are required.

Tip: When attaching the Back Frame Hanging System, Artiteq recommends placing the profiles 100 mm from each side of the printed panel.

Using the Back Frame Hanging System is recommended when the panel to be hung falls within the specified dimensions, see the table.